Switching E and X boards?

[theraidenproject]

My X comes tomorrow in the mail, but it's got 2.x My E has 3.2 Can I just unplug everything and switch the boards or is it more complicated than that?
If it changes anything, my E is pretty old, one of the first 300. Thanks for the help.

[Dayspring]

You'd need to either remove the entire innards, or un-solder the noid from the board and switch them.

[theraidenproject]

Damn, guess I gotta play with the old software for a while.

[ah137]

You can switch everything; there is no difference between boards. You can leave the solenoid on the board also. But you need to unsolder the power and ace wires from the X-mag board.(and solder them back on the emag board)

Hills

not sure what dayspring is saying

[theraidenproject]

While I am fairly confident with soldering, I don't want to risk anything. I'll just wait til I can get it reflashed.

[ah137]

grow some Wuss, you asked. ha ha just kidding. really it would take less then 5 mins.

But ok later Hills