hey guys,should the emag sear have the roller bearing set up like the rt sear, or should it look like the classic sear with just a open hole for the sear pin? i just got a used micro emag,and while attempting to adjust the trigger i noticed that where the pin goes through the sear was sloppy,there was no roller bearings just a big hole like on a classic.
-
-
Emag sear comparison
Edit, ok micro emag sear should be the size of an automag sear with a brass bushing.
Left emag sear right micro emag sear
Center AM/MM/Micromag sear
Old school rt, is the only one that has the bearings.
Hills
Edit pic is not workingNVE-mag
Certified Airgun Tech.
-
ok, my emag sear just as a big hole, no bushing, i guess that means i need to get a new one?Comment
-
Micro emag sears have a steel bushing...not brass. They took a great sear and ruined it...
Comment
-
tunaman, a agd sear will not work?Comment
-
put the sear pin, in the hole is it a tight fit or is it just way off, thats the real question.
No matter what you do a emag sear will not work in a micro emag. The micro emag sear pin hole should be the same size as a normal mag sear. if yours in not you have a problem, but I don't think you have the wrong size in there or I don't think you emag would work at all.
Figure it out yet???
Later HillsNVE-mag
Certified Airgun Tech.
Comment
Comment