Gun firing full auto

[Corbet]

After changing springs, oiling my gun (oiling EVERY o-ring in the valve), and adding a on/off adapter my gun now shoots full auto. I didnt mess with anything, and I was wondering what could cause this? Lvl 10 problem?

[RRfireblade]

If you pull the trigger and it goes auto,let go and it stops.....

Your missing or messed up an o-ring in the on/off.

ULT or not? Then it's may be a shim problem.

[Corbet]

No ULT. heres whats in my on/off:

1 pin, th metal shaft with o-ring on it and a white o-ring on the bottom of it, the brass piece (does this have the + go up or down?), a stiff white o-ring, and at the bottom is a o-ring. anything missing?

[SpdElemts]

Check your Bolt and sear for any wear. It could be that your sear is not catching the bolt. so check those

[RRfireblade]

It goes in the hole in this order....

Large white o-ring in bottom of hole,

Assemble silver body w/ on/off pin inside.Body with grooved end going in hole last and groove in pin on same side as groove in silver body.There should be a small white o-ring in end of silver body.

On/off top over pin w/ X so it's facing towards the outside of hole,against the silver body and then a small white o-ring on last.

Slide the assembly in hole.

FYI, that's the OLD style on/off top and you'd benefit from replacing it with the new style.

http://store.airgun.com/index.cfm?action=cat.prodInfo&productID=25&categoryID=18

It flows much better than the old style.