X-mag electro problems

[oldsoldier]

Ok, I am experiencing aproblem with my gun. It seems that, while in E mode...I will start to rip on the trigger...then the gun just stops. The electronics are still on, but the solenoid doesnt trip. I switch to manual, fire astring, then flip back, and its fine, till I rip on it again. Then, thesame thing happens. Any idea what this can be?
The only thing not stock is my TL63 trigger...again, this is the first time it has happened.

[deadeye9]

You might want to check the plunger depth, should be 3.005 in.

http://www.automags.org/forums/showthread.php?threadid=120738&perpage=30&pagenumber=5

[oldsoldier]

Up...anyone else? Impossible for me to check that...zero access to a caliper.

[oldsoldier]

UP again for the night...no one else?

[Mag_SEAL-6]

What version software do you have? With the 4.0 they just figured that after about 20 bps the solenoid starts to trip up. Take a look at the thread on how to fix it.

[lamby]

I have a TL63 also (it rules). It sounds like your problem is the "back travel adjustment" on your trigger. The screw that is in the trigger that you can adjust from the trigger frame is for "front travel" the amount of travel the trigger moves before it fires. Adjust that one first so you get the travel the way you want. Then remove the trigger frame and adjust the set screw that is in the selecter block to adjust your "back travel" if there is not enough "back travel" you will get this problem. It sounds like you are right on th edje of the "back travel" reqirement so you might only need to turn the set screw out 1/16 of a turn. Do you still have the trigger rod in? If so, adjusting your "back travel" will also effect your reactivity. Simple fix and you would just have to adjust your trigger rod in or out to compensate. Caution you might loose manual mode with this adjustment!!That is why I pulled my trigger rod out. (too much reactivity for tourneys)

[Emily]

Enigma at emilys

I had the same thing happen with an emag, I found that my battery had a bad cell, with a fresh charge it would shoot fine but it quickly ran down, when it did ithis and I went to me and back to E mode it would shoot a bit more

[Flossabe]

TL 63

I have found the same problem with my emag, and I am using the TL 63 trigger, I have ben playing around with it seeing how fast i could get it and on extreme adjustments it will not shoot unless you shoot it a time or two in manual mode (or at least that is what I have found to fix it) but I will try that back travel adjustment.

[lamby]

fossabe: you have a pm

[Doobie]

Trina's X-mag is doing the same thing. Has anyone figured this out for sure? I will mess with the trigger adjustment a little later today and see if that fixes it.

[cgrieves]

After the marker has stalled, will it fire if you switch to ACE 0? I had a problem on mine where you could rip up to apoint then it would stop dead. Turns out that the ball is rolling forwards off the eye and resting against the lip of the barrel, so the ACE detects no ball but the following ball doesn't quite get far enough in to cause a double feed.

In my case I'm pretty sure it's the detent, so I have Kila magnetic detents on the way.