worp feed

[flatlineklick]

i dont know if anyone asked this but here go's...i have a kick@$$ micromag and i have a worpfeed on it. i went to a weekend full of paintball and in a middle of a game my worp would not move unless i push that white button.what happend? and i am in the market to get the ifram and rt, where would i buy?? thanks

[angelbeast24]

try turning up the senistivety on it

[flatlineklick]

tryed that

[angelbeast24]

are the shims tight enough to hold the paint?

[vf-xx]

could be your battery is dead.

[flatlineklick]

i just put a new bat in and i made sure everything was tight

[frenchman309]

This happened to a buddy of mine just recently. His problem ended up being that his board was fried.

[flatlineklick]

oh dont say that, if i get the iframe, will it work then?

[felony]

I would try new batteries in the warp.

also, check the dealer forums, I believe rogue or tuna may have intelli's for sale. Check the F/S forums for one used, or go to store.airgun.com to get some direct from AGD.

If the sensitivity thing isnt clicking on for the warp to feed, an I frame intellifed may help. You need to work that yourself though and buy parts for it


dan

[Bad_Dog]

happened to me... the vibration sensor in the shell got wet and corroded so that the springs wouldnt vibrate... i solved it by intellifeeding it to my frame...

[PowderdToastMan]

I had the same problem, change your bateries again

[lamby]

if the button works and that sensor does not, the sensor is prob toast (or the board came loose preventing contact with the sensor via the little springs) Intelifeeding should fix the prob or a new sensor from AGD