x valve

[ricor3]

sometimes between shots... i hear air leaking out of the valve...i can pull the trigger and sometimes it goes away or if i move the air line into the valve it will stop??????help

[eddie885221]

lookat the manual cuz i aint big tech guy when it comes to mags but u have to adjust the shims and carriers

[eddie885221]

or if u have been usin it for about 2 cases of paint then u have to go to the next size up in springs cuz the o rings have been broken in

[Dayspring]

Or not.

Where is it leaking from? Or how is it leaking?

Gas it up. No paint. Does it leak this way? Push your finger up against the bolt- does it stop leaking or does it change tone?

If it stops- add a shim.

If it changes tone- go down a 1/2 size on the carrier.

Originally posted by eddie885221
or if u have been usin it for about 2 cases of paint then u have to go to the next size up in springs cuz the o rings have been broken in

[ricor3]

x-valve

pushed on bolt stopped leaking ....opened it up... no shims ...1 still leaked....2 still leaked....3 still leaked

[Joni]

Maybe try go down one size carrier?

Dayspring, I was under the impression that if you have a shim leak, you have to remove a shim? The installation manual states that you should start with no shims to make sure that there would not be a shim leak.

[ricor3]

how do you get carrier out???

[ricor3]

x valve leak solved

got carrier out went from 1.5 to 1 and it stopped leaking yeah!! thanx for the help