HI all my question stems from a want fora certain look to my mag... i got my ule custom with the stock rail and forgrip... i am getting a logic vert frame in the mail soon and i want to lose that brushed aluminum bracket that holds the foregrip on the current RTpros. the way i can see doing this is taking the bracket off and drilling the remainder of the hole in the rail that will let me screw my ASA into it. i when i "mocked" this up it seemed that the forgrip would be kinda far away for my liking. the current partial hole in the rail would put the foregrip about 1 inch ahead of the trigger guard on my intelliframe (this should be right about the same for the logic). i would like it to be close, nearly touching, for the compact look...
i thought i would pull out my classic and put that rail on there and see where it touched... i have a great foregrip on my classic and when i slipped that rail onto my intelliframe... it fits great... the only problem is that i have to take out the twist-lock barrel pin thing to get my ule body on there.... other than that the rail is smaller, lighter, and the foregrip is already there and in the right place....
here is my main question... will the classic rail work with my X valve, ult, and ule vert body setup? according to the tolerances thread by BlackVCG, the length of the on/off pin for my working classic rail/valve is .750" and the trigger rod length is 1.985"... these lengths are the same for the RTpro's trigger rod length and for the Retro Valve/X-Valve/Classic RT on/off pin length.. will that change with my ULT setup???
sorry for the garbled post... but i'm confused and concerned... i dont wanna mess somehting up bad... as usual, all help is greatly appreciated in advance.
-kyro
i thought i would pull out my classic and put that rail on there and see where it touched... i have a great foregrip on my classic and when i slipped that rail onto my intelliframe... it fits great... the only problem is that i have to take out the twist-lock barrel pin thing to get my ule body on there.... other than that the rail is smaller, lighter, and the foregrip is already there and in the right place....
here is my main question... will the classic rail work with my X valve, ult, and ule vert body setup? according to the tolerances thread by BlackVCG, the length of the on/off pin for my working classic rail/valve is .750" and the trigger rod length is 1.985"... these lengths are the same for the RTpro's trigger rod length and for the Retro Valve/X-Valve/Classic RT on/off pin length.. will that change with my ULT setup???
sorry for the garbled post... but i'm confused and concerned... i dont wanna mess somehting up bad... as usual, all help is greatly appreciated in advance.
-kyro
Comment