I was switching bodies with my friends ULE body on his emag for my stock body on my RT pro, and I had to hammer out that little metal thing that sticks up so the barrel can twist and lock into place, but when I hammered it back in on the E mag the small metal end got hammered in and now the barrel doesnt lock.... anyone know where I can get a new one?
-
Come see me when you get nyce -
you can get one from airguns store. But before you do that you might wanna try and unscrew the the screw on the bottom and pop the pin out sand off any of the burs and reinstall. Also use a rubber mallet and remove the pin and spring before you install the new one if you need to get it."Your just a myriad on inner conflict aren't you?"
Good Traders: deathstalker, Der Cockermeister, Target, brtncstm160
Bad Traders: None, yet..........
"I have to think of some creative quote to put here don't I?"
Feed Back:http://www.automags.org/forums/showthread.php?s=&threadid=119588 -
Welcome to AO. You can probably get the twist-lock thingy at AGDs' store.
store.airgun.com
Hope that helpsComment
-
argnot is right, that piece can be taken apart and fixed, unless it is really beaten up.
I wouldn't have been able to give the ULE body back. Ditch the stock body and get a ULE!
link to twist lock assembly:
Comment
Comment