Has anybody done this? I think I might have it worked out. I just ordered all the parts I think I need for it. I have a WGP Orracle, and my plans are to use the bent part spring in the front of the handle to push a little switch (just in case you have a WGP handle). From there, I'll route the wires (they'll be thin) accross the top of the grip, behind the sear and below it, and then run them though the tapped hole in the bottom of the upper part of the frame, thus getting the wires to the middle of the grip. From there, it's basicly the same as any other intellifeed mod, with the groove cut in the grip, although I plan on putting a little LED in the main part of the handle, and drilling a hole the grip to know when the switch is working. I'll post back in a bit when I get my warp and I do the mod to let you know if it works out.
- AO: We are back from the dead... again! After an 18 day outage, we are finally alive and well. Who knew how complicated updating software/databases from 2008 would be. I still have alot of tweaks to make, but my main goal was getting everything patched and updated to 2026. Vbulletin 6 has changed alot since 2008 so we will have a ton of new features to dig into.
Comment