I got my Micro E-Mag back from AGD for some work and everything is great except that when i put it in E-mode i get the RT kick like its in hybrid mode and in normal hybrid mode its way too easy to find that special spot on the trigger to make it go FA... much easier than before. I think perhaps my trigger rod is too long. I know you're not really supposed to mess with it but I know it shouldn't be long enough to be making contact with the trigger in E-mode. any ideas?
-
-
Adjust the HES magnet to fire as early as posible in the pull and then reset the trigger stop(the one inside the selector switch)for the least amount of over pull that still fires reliably.If that doesn't fix it,
Shorten the trigger rod a half turn past the point where it stops hitting the trigger in Emode and you should be good.Logic Paintball Forums
My A O Feedback Here
Other Feedback Here
If I've Been Any help
Please Leave Some. :)
-
if i adjust the HES magnet out anymore then it creates problems in hybrid mode.... ill keep messing with it.
thanks.Comment
-
Unfortunatly,that the problem with the whole design.There really should be no hybrid mode in the first place.Logic Paintball Forums
My A O Feedback Here
Other Feedback Here
If I've Been Any help
Please Leave Some. :)
Comment
-
Re: Micro E-mag trig bounce in E-mode
I agree. I believe the trigger rod is too long. Check the specs on BlackVCG's thread in Tech and compare that to your trigger rod, measuring from the tip of the rod to the back where the pivot is.
Originally posted by la690
I got my Micro E-Mag back from AGD for some work and everything is great except that when i put it in E-mode i get the RT kick like its in hybrid mode and in normal hybrid mode its way too easy to find that special spot on the trigger to make it go FA... much easier than before. I think perhaps my trigger rod is too long. I know you're not really supposed to mess with it but I know it shouldn't be long enough to be making contact with the trigger in E-mode. any ideas?Comment
Comment