warp feed RPM and Torque rating

[Drizit]

[ah137]

The warp board can take 12 volts and the halo takes 9volts.

I think the warp motor is a common radio shack part so you can look there for further info.

PS the limiting factor to the amount of paintballs the warp can push is going to be the size and pressure of the disks (friction). Buy increasing the rpms or torque its not necessary going to help you. Your going to need to do some testing to figure this stuff out.


Hills

[Drizit]

[yaddatrance]

The problem is not the warp per se, you can actually
make the warp quite torquey by adjusting the feed
width, the problem is that if the tube is too long,
then the weight of the paintballs themselves could cause
them to burst. 3 feet should be no problem whatsoever
on a stock warp though... Try it first before you
change out the motor. That would be a neat test though,
to see how high the warp could drive a stack of paintballs
vertically.

[Drizit]

it would be, i won't be driving them compleatly verticaly though it's going to be mostly horizontel with only about 6 inches of rise. however i also want 25+ bps it's for an RT tippmann98 after all.