Pure Energy Tank Help

[[email protected]]

- My tank is leaking very bady cause the pin sticks open. What should I do? I bought it used so sending it back is pretty much hopeless. Thanks

[SeeK]

The fill pin or the ASA pin?
Your local airsmith should be able to fix it with an o-ring

[[email protected]]

ASA pin, where my on/off pushes in the pin.

[SeeK]

I believe they have a 1 year warranty.

It's a rebuildable and the PE site has a rebuild kit.

http://www.pminetwork.com/pe_accessories.html

The pictures look like only the O-rings would wear out and most likely be available from the local air shop for much less than shipping.


http://www.buypmi.com/downloads.html
Click on Pure Energy, PE Inline Regulator.

It even has the exact size of the o-rings if you see one that is cut or damaged.

[RRfireblade]

Originally posted by Branden Minimag
Doesn't matter if it's used. Call PMI and they will fix it for you. You'll have to ship it out to them.

If it's the new style they'll fix it for the cost of the o-rings,if it's the old style they'll usually only replace the reg with the new style reg @ $50.

The old style reg has NO set screws anywhere around the upper silver part of the Reg,it's locktited together and can rarely be seperated with out damage.

PMI,as far as I'm concerned has awesome service.At World Cup they replaced my older,out of warrent Reg w/ the new and did so at no charge.Unusual I'm sure,be still awesome if you ask me.I'd go ahead and send it in if it's the older style.

[Morally0Confused]

i had a prob like that on a CO2 tank i used my car keys and wiggled the nipple around and the blast of air blew out my guess was a few grains of sand holding it slightly open