Test fired my new mini-mag, and noticed after i was done that the logo on the valve was no longer lined up like it is when you reassemble it. The rear half seemed to have unscrewed itself mabye 1/4" or so. Is this normal? if not, what can I do to stop it from happening?
- AO: We are back from the dead... again! After an 18 day outage, we are finally alive and well. Who knew how complicated updating software/databases from 2008 would be. I still have alot of tweaks to make, but my main goal was getting everything patched and updated to 2026. Vbulletin 6 has changed alot since 2008 so we will have a ton of new features to dig into.
Comment