MiniMag E-Trigger...

[abartjc]

Does anyone know where I can get an Electronic Trigger for a MiniMag? I have searched e-bay and all over the internet and have found a company by the name of Mako but have found no place to order one. I just sent off my stock valve to be exchanged with a X-Valve so I am going to want to get the most out of this bad boy. Any help is good help!

Thanks,

abartjc


MiniMag
Lvl10
300PSI 88ci
12v ViewLoader with Xboard
ACI Drop Forward
ACI Expansion Chamber (just in case I have to switch to C02)
*Awaiting my X-Valve*

[redlaser666]

Mako or Boo Yahh (same thing) went out of buisiness. The only ones still in production are the hyperframes from centerflag.

[Skywalker]

wait for coolhand to come out with the electronic logic vert frame, it's gonna be very expensive tho.

[Cryer]

and a long wait...

If you want one sooner talk to GA Devil. He's a centerflag dealer.

[tjmpaintball06]

instead go with an intelli w/ ult, you will have less problems

[DeeEight]

heh, my problem right now with my booyah frame appears, after further testing, to be the valve not refilling fast enough to keep up with cyclic rates over about 6bps. I'm not sure if the booyah supplied on/off valve pin is venting too much gas pressure out the bolt when the thing fires or if something else is restricting the gas flow (braided hose off the vert adapter, running a bare co2 tank - 16 and 20oz - for testing the grip). Pondering putting the stock on/off back into it. Suppose I might as well put a few balls across the chrono first to be sure.

[hostage]

hrmm...sounds like it is a problem with your valve and not with the booyaah, try putting oil in it and look at the orings inside. The stock on/off wont work.
-Hostage