Can you Intellifeed an E/worr-blade?

[Lord_Whoopass]

Just wondering if you could Intellifeed a E-blade or worrblade and if so How? I checked out Rob's page but alias nothing... So I am just wondering... Please help...
Tyler

[Mag_SEAL-6]

I'm not familiar with the worrblade so i don't know if they acvtually have a set up feature to where you can conveniently intellifeed it.

I'm sure you could probably rig it up somehow, but i've never heard of anybody doing it.

[Lord_Whoopass]

yeah thats why I looked at RobAGD's page because he has done it with a shocker, impy, matrix, etc... but no E-blade or worrblade... I was just wondering if anyone did it before...

[lamby]

according to elcipse, the 1.07 software has an adjustable setting for warps. the problem is that there is no connection on the current board for the warp and the 1.07 function requires a new board. I have not seen this new board, but I have someone looking into it at the beach this week end. I also need a nexus kit in a bad way so I hope I can get that too....

If I hear anything I will let you know

[xen_100]

it shouldn't be too hard. take a DMM and measure the output from the opto-coupler that they use as a trigger switch. more than likely you will be able to just take that and put it directly into the warp.(make sure you have the warp setup for the correct input) you might want to isolate it with a second opto-isolater just to make sure. but that should be cake!

[Lord_Whoopass]

Thanks lamby... I had heard something like that as well but I didnt see any hook up to the board... only way I could think of doing it was the way Zen said, by hacking into it which of course voids the warranty... LMK Lamby if you find out anything...