I have a leak out the back velocity hole adjuster of my classic 68. I know there is a safety feature where it bleeds off if the velocity is too high, but if I turn it down to the point of when it stops, the gun wont fire because the velocity is too low. Any suggestions on how to fix? Its small, but very annoying. One more thing, I just installed a level 10, and it seems to stop some chopping, but it still chops more than I would expect. I have a halo B on it, could the Halo cause it to chop by pressure feeding the balls causing a double feed? The paint is good paint. I was thinking about downgrading to an evo2 or more than likely a revvy.
-
-
You need the new HP reg piston... -
Real quick about the level 10 thing. I just opened my gun up, absolutely no paint on the level 10 or the insides of the gun, it was spotless. Means that the paint was either bad or maybe the ball detent is crappy? I have an old school all american barrel and I have to say the ball detent does seem pretty week. Anyone know where I can get a plasic one? Can't find it anywhere.Comment
-
you can buy them from AGD seperately, or they are included in the parts kits.
Comment
Comment