Need Emag help ASAP Gun going F/A

[pblcd]

k guys this is what i have.

I dont have air hooked up and im pulling the trigger and it goes full auto. Now my low batt. is blinking so does this have anything to do with it?

Now when i put air on the gun it will not shot!

Need help asap tourny tommrow

get me here or on aim cla225

thx a million if someone can help me i will hook them up(im a dealer)

[pblcd]

A little info if needed:

this is a lvl 10 with 4.0 software and it has a ule body

[Potatoboy]

having a low battery helps nothing.

charge your battery and see if it's still doing it.

when did you get the 4.0 software, it's been recalled.

if after your battery is charged you're still having issues, there may be a couple of things wrong.

[pblcd]

I have been chargeing it for 2 hours now how much time is needed? also what else can you offer, if its not that?


I think it has something to do with the tigger setting, what you think?

[pblcd]

also about the 4.0 software, i got the gun used and the guy before me had it do.

[Potatoboy]

your solenoid wires may need reversing to cure the FA issue.

AGD 3.2 is the current version of AGD supported software. This is the software you should be using.

[pblcd]

Now understand the Fa is only when the gun does not have air, when air is hooked up it will not fire(now this morning the gun was ripping

[Potatoboy]

Correct. That is a symptom of a bad solenoid wiring. The fact that it's not firing now leads me to believe your battery is dead.

[stealth assassin]

Originally posted by pblcd
Now understand the Fa is only when the gun does not have air, when air is hooked up it will not fire(now this morning the gun was ripping

Sounds like the polarity from your Solenoid is causing problems with your trigger sensor. Try switching your Solenoid wires to change the polarity. It solved my problem.:)

[pblcd]

well i just check the bat in the gun and it still said low batt. its been 4 hours!!

think my bat is shot?