micro mag

[Blackjack2575]

I have a micro mag power feed, I need to find a vertical drop ball feed for this marker, I have a halo on it and it jams, there r two allen heads to remove the feed off the body does some one make a vertical feed that will bolt on to this marker, I would like to keep this marker if at all posible.

[peewee]

The power feed & a standard feed adapter is all that I have ever seen for the micromag prior to the 2000 that was a vert body. I tried to get a standard feed but was never able to get my hands on one. I would check with a local machine shop & see if they would make one, there are several in my town that do mods fairly cheap.

[Blackjack2575]

machine shop

Thinks looking into that too!

[50 cal]

I had a Micro that would jam up in the powerfeed. I had to remove the PF and put a bit of JB weld to hold it in position.

The 2 screws that hold the PF in place are pretty small and weak. One or two hits from knocking it into a bunker, like mine had, will keep the screws from holding it secure. Just JB Weld it and all will be good.

[ChucktheMAGician]

Making it a vertical would require quite a bit of work as the actual hole that the ball goes thru is on the side of the body. That hole would have to be covered and a new one made.