I can't seem to get my emag valve out even after trying to pull the trigger to release the on/off. I end up having to take the rail off to get it to come out. Anyone know what causes this and what the solution(s) could be?
-
Click For a Free IPOD!!! IT Really Works!!!
Graphite Fly A4
14" Freak/Black Uni-Mount
68cu/4500psi Crossfire
Egg2 with Z Board
Email: [email protected] -
I use to have the same problem, but I could never figure out what was wrong. I would just keep messing around with it and hopefully it will pop out.Dust Green X-Mag #315
ULE body w/ dual Kila V2 detents, X valve w/ LX, Y-grip w/ Dye grips, ULT, Omega rail, Stainless Steel Freak Kit.
My Feedback- http://www.automags.org/forums/showthread.php?t=165428 -
always put the marker in manual mode and pull the trigger to remove the valve. You must push the on/off pin up first or it wont't come out.
Comment
-
Also,depending on the trigger rod adjustment on some Emags,the sear won't completely depress the on/off pin in manual mode.
You can ramp the rail with a small file at the rear of the on/off milling to allow the valve to be pulled in that occasion.Logic Paintball Forums
My A O Feedback Here
Other Feedback Here
If I've Been Any help
Please Leave Some. :)
Comment
Comment