Level 10 Bolt still chops...pls help

[abunkerer]

I agree with an earlier post (calimagfan)It sounds like something is out of allignment, maybe try your setup in someone elses mag frame.

[darrickws]

Good idea...

Will swap with my level 10 minimag, and see what happens.

[BlackVCG]

Try adjusting the field strip screw torque. If you usually just hand tighten it, try fully tightening it with a field strip screw or vice versa.

If the mainbody/barrel alignment is off, this can cause a problem with the bolt sticking.

Also, there is a chance the bolt wasn't manufactured properly, so try a different bolt and see if it stops on the paint or not.

[darrickws]

You guys are awesome!

Well looks like it ended up being the front screw! My other 2 mags with level 10s has small washers under the frame screw, this one didnt . I added a o-ring as a washer and now it works great!

THANKS!!!!!!

[CaliMagFan]

kudos!.... those pesky frame screws.... this is what AO is all about...

-kyro

further problems? consult the link in my sig.