Annoing Z-Grip

[BlackHalo]

I was thinking of getting a Z-Grip annoed and I had a few questions.

There is this little metal part in the sear area -



I can't tell if it's aluminum or not. Does anyone know anything about it?

Also, I know I have to tap out the trigger pin, but which side do I tap.

It's a classic-RT Z-grip, there is a brass(?) ring in there. Is it ok to leave this in or do I have to remove it.

How the heck to I get the safety out?

Thanks!

[BlackHalo]

anyone?

Nobody knows what the little round part is/does/is made of?

[spyder_strypes]

If the safety is the same setup as it is on the intelliframe, unscrew the set screw that's on top of the frame. It's very very small, you'll need a very small allen wrench to unscrew it. Under it is a ball bearing and a spring..don't loose those. You should be able to take the safety out, but I know Halliday at PBR said that he's never seen some one take a safety out, and put the same one back in.

I wouldn't worry too much about the metal part and the brass ring...I doubt that they could cause something in the anno to go wrong.

[BlackHalo]

Spyder

Thanks Spyder_stripes!