I just set up the level 10 bolt for my orginal RT mag. I think I am useing the correct carrier (1) because it leaks terribly out the barrel with a 2, the bolt is cocked, and the trigger gasses up, but even when the volocity is turned to max, it still will not fire. Absolutely nothing happens when I pull the trigger. Any solutions?
-
-
Try the 1.5 carrier. What spring are you using? Long, medium or short? -
medium.
Comment
-
I tried the 1.5 and am haveing the same problem.Comment
-
Yes! I got it working. I needed to use one shim.Comment
-
I spoke too soon. Now it alternates between being able to fire, and not being able to, and when it's able about once every 5 seconds. And it leaks out the regulator nut.
Also, I have to set my tank output up to 800 psi to get the trigger to gas up.Last edited by Mr. Peanut; 04-03-2004, 05:53 PM.Comment
-
This time I realy think I got it working. The sear wasn't engaging the valve because the rod behind the trigger was to short, so I had to screw it out a little, and now it works fine. It seems to work with no shims at all, the bolt didn't get stuck or anything when I trid blocking it with an allen wrench. Well, if it works, it works.Comment
-
The trigger rod comes set at the right length. See the tolerances thread up above. If your sear is not at that spec, return it to factory settings.Comment
-
It was working right before, it must have just slowly pushed it self in, coinsidently it went to far when I was installing my level 10Comment
Comment