Xmag won't shoot in E mode????

[Willystyle21]

Had this happen once before ( although it was a regular Xvalve I had thrown into the gun because it was already hooked up to air etc.) . All good to go the last time I tried it in E mode. I turn on my Xmag today to test out the new warp and in Mech and Hybrid all works fine, however when I turn it too E mode to test if the warp spins when it is given it's signal from the gun, no worky. Kept pulling the trigger, it would not fire. The shot counter never went up in Hybrid or E mode either. Could the battery be getting to low, or is it the On/off pin problem. The previous owner had the pin shortened to prevent this.That is why I'm leaning away from it being the pin ( because it worked up untill now).

Where can I get the wall adapter for the car chrager. My cirgarette lighter in my truck never worked to begin with.

[ryanshep]

same thing happened to my emag, i just had a low battery, and btw u can use any 12v adapter that u can buy at radioshack for the charger

[Willystyle21]

Tried that been charging the begesus out of the thing with the car charger. No worky. Also picked up a charger from Wallyworld (one of the all in one with 7 adapter's thing which you could reverse the polarity) and while I thought it would work great began to overheat the charger while causing my house to smell really bad. Took the charger assembly apart ( it still used the car charger one) and found the power wire had burnt through on the voltage regulator. Moved the wire off the reg and just stuck with the car charger. Haven't gotten to try it yet.

[SuiciDal Sn Y p ER]

your trigger pull could be too small, that might cause the gun not to fire

[Willystyle21]

Tried that already, although it did start to not fire after I adjusted the magnet in the trigger. But afterwards I backed it as far away from the sensor as possible and it still would not work. Still charging the battery. We will see later tonight or tomorrow.

[Willystyle21]

Figured it out

You know it just hit me, my ACE was set at 02. Turned it to 00 and it works fine. Now my next question how do you properly adjust an ACE?

[BlackVCG]

You know it just hit me, my ACE was set at 02. Turned it to 00 and it works fine. Now my next question how do you properly adjust an ACE?

Take the breech off and hold a ball above the eye with it in Mode 1 and and keep tightening/loosening the adjustment screw on the left side of the frame until it doesn't fire until the ball is about 1/16" above the eye.