Z-Man's Loosing It...

[Z-man]

[Z-man]

Wiat wait hold everything! I think I fixed it..... one moment.

[toolfan62]

turn ur safety off lol jk

[Steelrat]

What did you do, put the battery in? Turn the gun on? Pull the trigger? LOL

[Z-man]

Oh shut up it wasn't that bad. It's almost done and then Ill deal with your insolence.

[Blennidae]

Originally posted by toolfan62
turn ur safety off lol jk

I agree with this statement...

[Z-man]

OK so there was this magnet see... and it looks the same on either side. And even with my impressive array of skills I cannot tell north from south on a featurless magnet since both poles are attracted to the Fireblade screw...

Anyhow now that we have that out of the way we can discuss the results that I found.

I moved the sear pin back almot a full 1/10 of an inch to about 2.078 inches long.

This took care of the full auto E-Mode and made hybrid mode much nicer to deal with as well.

I did however discover one of the things that happens when you move the sear pin back. Sometimes you cannot get the valve off because the sear wont go all the way up to push the pin all the way in.

While this is a small annoyance, it begs the question: what do all you E/X-mag users without sear pins do about that? just take the body off and push the pin in then?

On a final note I did plan on putting out another video with improved expressions and better sounds but I had so much fun firing the SFL that I ran out of the very last of my air.

Tomorrow then, woot!

[BlackVCG]

I don't have a trigger rod on my E-Mag, actually I don't have a trigger rod ARM on my sear. :)

To push the pin back up in, all you do is completely degas the gun (Quick Disconnect) and then with the gun still turned on, pull the trigger and since the on/off pin is pushing down on the sear the solenoid will pull down the plunger and push the pin all the way up into the on/off.

[Z-man]

oh yeah... kinda forgot about that solenoid.... <slaps face>