Chipper's (ghetto) Trigger Mod

[Chipper]

Disclaimer: This might of been done before, and I did not notice it. Oh well.

I got to thinkin yesterday (quite rare for me) about ways to decrease the travel of the trigger on my Intelli. I noticed that the trigger hits the pin, which moves the seer, ect. So I figure that if you increase the size of the trigger in the area of the pin with, say, a small piece of duct tape, the the trigger does not have to go quite as far.

Does anyone know if this will work? and if not is there another trigger mod I missed?

[Mer]

Hey Chipper,

I think it's basically the same as this:

http://www.automags.org/forums/showthread.php?s=&threadid=131605

[phyregod]

GOOD GOD MAN! PUT THE DUCT TAPE DOWN!

[RRfireblade]

Re: Chipper's (ghetto) Trigger Mod

Originally posted by Chipper


Does anyone know if this will work? and if not is there another trigger mod I missed?

It's not a mod,it's a spec.

As in,the spec for the trigger rod to the trigger(AKA gap),as reccomended by AGD being no more and no less than 1/16" of an inch.