Ricochet Apache on Warp Feed Fit Problem

[Raven4000SX]

Does anyone out there have a Ricochet Apache on their Warp Feed? If so here's my problem. The Apache comes with 3 different sized o-rings. With the smallest o-ring the loader fits too tight in the warp. I've pulled the loader out a few times and since it's a very tight fit it's difficult and chewed up the o-ring. Now I don't have an o-ring to use. Without the o-ring on the neck it's too loose. What can I wrap around the neck of the Apache to get the perfect fit? I tried tape but it doesn't work.

[TheLaxPlayer]

What kind of tape did you use?

I have seen the rubber electrical tape used before, and it seemed to work very well.

[Raven4000SX]

I had masking tape but was thinking about electrical tape. What is Rubber electrical tape?? Never heard of it.

[TheLaxPlayer]

Just the normal kind, I just meant it is kind of rubbery and that makes it hold well in the feedneck.

[Raven4000SX]

I'm gonna try that later. For now I put a Warp Feed hose 0-ring on it, which is thinner than the original Apache ring. It seems to be a perfect fit. I'll post pics of my gun once the film is processed.

[AGDlover]

a rico should fit just put the orings on and loosen up the warp screws and just slide it in and it'll fit

[stealth assassin]

I use 1 and a half wrap of the vinyl electrical tape and it works great.

[Raven4000SX]

I have to call myself DUMB on that one. I didn't think about loosening the screws on the Warp first. Then it wouldn't be so hard to put on the Apache. he he I chewed up one o-ring already taking the Apache on and off.

thanks guys.