I have a Micro-emag. The sear is cut in half. I was dryfiring in my backyard (good weather, was oiling it). I noticed that the sear was flying all over the place behind my trigger. I took off the grips and said "wtf?" because the sear was cut in half. So the gun functions in E-mode, but manual is shot because there is now nothing pushing against the trigger.

That is where it is cut, clean too. Is this covered by AGD? I'm kinda bummed out because first it sheared an On/Off pin, then the AGD charger crapped out, and now this.

That is where it is cut, clean too. Is this covered by AGD? I'm kinda bummed out because first it sheared an On/Off pin, then the AGD charger crapped out, and now this.


Comment