RT Problem --HELP!

[hacksaw1]

Will having low tank preassure cuse the RT not to fire. The other dayed I aired it up on a SCUBA HPA and found 200rnds. with no problem, then i brok a ball and stoped, cleane barrel when got home and tried to fire again. The bolt stuck and vented all of my air in about two seconds. I went to fill up agin and the tank was low, it put about twelve hundred psi in my tank the bolt stuck again, I tok the valve apart and found a smal pirce of o-ring or somthing were the banjo bolt screws into the valve. I cleaned it ad it shot fine for about 25 shots and then locked up, I went ahead and installed my new lvl 10 to see if it might replace the problem, it shot fine after air up and really fast, but then it locked up and started to vent all my air. when I would pull the trigger it would stop untill I released it. I turned it off and back and back on and it would not shoot at all, I would pull the trigger and nothing will happen except a small trickle of air (I can hear) leaks down the barrell. I am sorry this is so long.

[ghideon]

Pressure in the needs to be at least 850psi, usually closer to 1000psi. If my tank gets lower than 1K, my E-Mag won't do anything but sit there and look mean. So make sure you're testing this on a decently filled tank.

For the Level 10:
How many shims are you using, what's the carrier size and what spring are you on?

[hacksaw1]

Im running three shims with a #1 CARRIER, I had my tank gased up to 3000 and know whin I pull the trigger it wont fire. It is like somthing is stuck or my on/off won't turn "on"! Do you think somthinf might be blocking my valve. the trigger charges when I gas up. thanks for your help

[ghideon]

Might wanna try turning your velocity up. You may not have enough pressure flowing into the valve. Which spring are you using?

[hacksaw1]

It Worked!!!!!!!!!!!!!, but know my bolt sticks.I half to take a rod and push it back about every thirty shots, I am at the end of my rope.HA HA

[hacksaw1]

Thanks !,now what!

Hey big thanks to "John" @ AGD TECH Group. My sear rod was off and my velocity neede to be turned up. Thanks to ghideon aswell. Right know I am running the shortest spring why would I want to move to the middle spring (lvl 10) and what changes will I need to make.?
THANKS