Converting E-mag to micro e-mag

[NJPaint]

List of things I need to do:

Remove sear from both guns, how to do?


I unplugged the boards and plugged them back in, neither board can 'boot up'. Is there something that I might be forgetting? It looks as if there is no battery. This is starting to scare me...


Next, the back of the e-mag boards is connected to a red wire, how do I remove this and can I just resoder this back on?

[NJPaint]

I don't understand this. There is only one lead coming out of the battery, I'm no electrical engineer, but shouldn't there be two? Gah i was told getting the boards out of these things was easy, I guess not...

[Tunaman]

I don't understand this. There is only one lead coming out of the battery, I'm no electrical engineer, but shouldn't there be two? Gah i was told getting the boards out of these things was easy, I guess not...

The positive red wire is connected from the battery + and goes to the board. The board gets its ground from the mounting screw.

[NJPaint]

ya, Dayspring helped me last night answered all my questions, I'm a moron.