hey guys....you know i feel like a dope for asking this...i need to know what i have to do to make my Ule custom rtpro compatible with an automag/minimag rail.....i have a classic rail on a classic mag..... for a while i wanted a different foregrip on my rtpro, so i put that classic AM.MM rail on that marker....I have the Ult, so that should have been fine.... cause its really the rail that defines what type of marker you have... it just became a ule body, x valved classic, right? so as of late i went back to taht config,.... it seemed to not work... granted my tank was low and is now out, so i need to test further...but i wanna know what i need to do.... change on/off pins?... the ult should work in both a classc and a rt valve, thus with both rails...right?.....
the reason that i really want to know all this is that i really like the new alpha rails from logic... and i like that positioning of the foregrip on the AM/MM rail.... so i want to know if i have to do much to get my marker working with that config.... oh btw.... i have always used the correct sear with either setup, i just leave the sears on the rail when i change what marker i have them on...thannks all.... i appreciate any help...
-kyro
the reason that i really want to know all this is that i really like the new alpha rails from logic... and i like that positioning of the foregrip on the AM/MM rail.... so i want to know if i have to do much to get my marker working with that config.... oh btw.... i have always used the correct sear with either setup, i just leave the sears on the rail when i change what marker i have them on...thannks all.... i appreciate any help...
-kyro
Comment