E mag warp left ULE body loose...... why?

[captain stabbin]

Hi i just got back into mags all- And when i take my X valve out of my emag- i can almost shake the body around; how do i correct this... A.k.a where are the screws to tighten the body in- im almost afraid to remove the grip frame because i have terrible luck with lost parts.

[Chronobreak]

the whole gun is held by two screw the filed strip in the back that hold the vavle and abck fram e then the front frame screw that holds the body and grip on as well most likely the front needs to be tightened or a new screw if its stripped

[captain stabbin]

im aware of the field strip screws im not that much of a noob hah- but thanks, however ive owned mags in the past and when i take the valves out of them- the bodies still dont wiggle around like this one... any other suggestions ....

[Joni]

Like he said, it's the trigger frame screw that needs tightening.

[Tunaman]

maybe the front screw is too long...

[Chronobreak]

anything funky with the frame milling to fit the ule? even tunaman seems bit puzzled

[Enemy]

check to make sure the frame screw isnt stripped thats all it can be unless your ule body or rail have some defect!!!!

[SpecialBlend2786]

yeah, maybe your front screw is stripped or something... thats strange.

[captain stabbin]

thanks guys, got it all worked out- screw just needed to be tightened... and i couldnt tighten it to how it needed to be because my allen key was stripped in that size... got new ones; all good.