modding and electro guru's needed! for E-Z work

[SoldierzHonor]

Ok heres the deal guys. Is it possible to turn a Z grip into an electro? I believe an E-Z grip would be the ultimate. Plus the name is catchy. E-Z Grip.

Would this be feasible and Im a tard on electronics so this is why Im posting here for any help on this. If its possible, I will make it happen. If not, I'll simply get a second opinion...or third..or fourth lol. C'mon guys, this would just be amazing.....um, or has it already been done before? I hope not lol. What would I need to get? Yes I already have a Z-grip, now I just need to guru's to assist on the endeavor. Any and all advice would be greatly appreciated. Please guys, if your not going to make a contribution....please dont post. Thanks in advance and...lets begin.

[Southpaw]

it would be not too hard but you would need a smaller solenoid
I have 2 z grips that I am thinking of starting I just need a smaller solenoid. I was thinking that a morlock would be perfect for this project as no visiable change except the wires for the power. This was put on hold untill the hair trigger comes out. As it might be easy to adapt that.

[RRfireblade]

Sure it 'can' be done.

It'll likely take a custom sear,aftermarket board(perhaps a morlock) and the rest of the electronics.(switch,'niod etc)