Questions about the Emag/Warpfeed/Intellifeed cable setup.

[Hasty8]

Okay.

I tried the search but the results were so daunting that I had to give after about an hour and getting no where.

I have an emag, a warp and the intellifeed cable. My understanding was that once you connected the first two with the third the warp would spin every time the trigger was pulled.

Unfortunately that does not happen. I still have to actually cycle the emag to get the warp to spin which leads me to believe that the intellifeed cable is not completely working.

I went over the warpfeed manual again and in the jumpers section it talks about which jumper to use if the marker sends a negative or a positive signal.

MY question is this. Which type of signal does the emag use? My warp is still set for the "sens"or position so I assume that is why the warp still needs to feel the emag cycle even with the intellifeed in place.

Any comments guys and gals?

Thanks.

[Butterfingers]

negative

switch the jumper to negative

[AGD]

Jumpers on the right side of the board should be in the middle and bottom. The interface cable should be plugged into the middle socket on the emag board and pluged into the warp. With the battery ON you should be able to pull the trigger and have the warp spin. If it doesn't do that call the factory.

AGD