Flatline Leak?

[Deadeye]

Okay, here's the story, I usually leave a little CA left in the tank after a game. Give it about a day or two, and the tank is empty, 'cuse my ignorance, but is that normal???

Any help would be greatly appreciated. Thanks!

[BlackVCG]

No, it's not normal. Is the serial number on the tank below 800 by chance? Call AGD for instructions on replacing the on/off o-ring.

[Deadeye]

Uh, you'll have to enlighten me alittle. Where's the serial number located? Thanks!

[BlackVCG]

Right next to the on/off knob. It should say FLXXXXX. Numbers in place of the X's.

[Deadeye]

Thanks, it's FL01248.

[BlackVCG]

Well then, it's a Level 2.0, but I'm still fairly certain that your on/off o-ring is bad. If you have an extra adjustable HPA tank you can replace the o-ring fairly easily by turning it down to a couple hundred psi output and attach it to the Flatline fill nipple with a female QD. Apply a quick burst of air with the on/off shaft out of the hole in the Flatine you're repairing and this should dislodge the o-ring.

If you don't have the necessary tools to do this, call AGD about sending it in for service.

[Deadeye]

Dude, I'm in Singapore. Think AGD can still help me out? Please LMK...