Am I going mad? trigger screw ?.

[Red_Spartan]

Hello new member here with my first post. I got a great working, and new automag rt pro with lvlX bolt and trigger. So I was tweaking around with it the other day, put it all back together, and I went to push my twist lock barrel back into the body, and I couldn't get it back in. So I looked down the feed and noticed the trigger frame screw poking a little too high so the barrel could not push in fully. I've taken the gun apart dozens of times! Am I going mad? I know I can just grind the extra maybe 1/8 to 1/4 inch off the trigger frame screw to make it work, but has anyone encountered this very strange occurence. I have absolutley no explanation for this. Thanks for any replies!

[bokraham]

just use a washer or two

[Chronobreak]

you can/should be able to dissabele the frameand adj the twist lock so its not soo stiff if thats the problem....

[Tunaman]

You might have a ULE screw...they are a little longer.

[Red_Spartan]

thanks

I'll just use some washers!

[AGDlover]

make shure the ball detent on your barrel is but bout at the top when your pushing it in