Cocker problem?

[paintballman333]

Hey guys I have a 2k1 STO cocker and everything is fine on it except my P&P Messiha reg. I has a small leak right where the reg screws into to the gun. I put teflon tape on it and changed the o-ring on the reg but it didnt really help. Any suggestions? Thanks

[Flow_Tech]

try cleaning out the actuall ASA on the cocker where the reg screws in,there may be a TINY small piece of dirt in there that is causing the leak..just use a paper towel,and wipe it out,or just run your finger along the threads,and or blow it out

[MagManULE]

could it be coming from the asa? Maybe the bolt holding the asa to the body is loose or the oring between the asa and the body is worn.

[paintballman333]

Alright all try all of your suggestions, thanks. Any other opinions?

[ronin]

it could be trying to trick you mine likes to do that. if the previous fixes dont work then the leak could be comming from somewear else and just is blowing that way (cockers like to be sneekey) ... gas up the marker and put the front end into a bucket or sink full of water to pin point the leak make shure you dry it off good when your done.