Frenzy board settings?

[MagManULE]

First off, the only reason I'm posting here is 'cause I know there's a lot of people here who know what there talking about and I can't find any official manual or literature on the frenzy board even at bob's site. Don't get me wrong I've had the same mag since 99 and like it even more with my new ule body and x valve but figured i'd try something different with the timmy. Any way if some of the timmy users with the frenzy could share their settings and suggest what works best with their guns I'd appreciate it.
btw, my gz is as follows,
clamshell frame
frenzy board
cp trigger
aka sidewinder reg
cp ram cap
lapco clamping feed neck
freak set
halo b with the rip drive(victory board should arrive tomorrow)

[Derman2k]

I've got an Alias and I've found pretty much stock settings work real good. The only thing I changed was the Debounce. I just put it down to 4. No bounce or anything either so .

And hey, Are you the guy who goes to MSG once in a while?

[MagManULE]

when you say stock settings do you mean delay eye mode or force eye mode?
i ask because mine came on delay with a 15 ms. bolt delay and it worked great, but me being me of course i had to try the force which should work fine if not better. But on force with a 1.0 ball in place delay i was chopping everything. it still works great on delay(after spending 15-20 min. cleaning the eyes) but im just curious if maybe the bip was too high. Oh yeah i've never been to msg where is it?

[Derman2k]

I use force on my gun, just because it makes sure that a ball is in there before it shoots. Delay is ok too if you've got a halo or something about that speed.

MSG is in Montgomery.