need help if any1 has a min

[mcdkid]

well a week ago my mag (micro e-mag body/valve + lvl10 + intelli) would only fire 1 outa 3 pulls and you could fell the preasure in the trigger. now it doesn't fire. me and 2 friend from my team (usually the threee of us could fix any mag) we replaced all the o-rings oiled it and now it doesn't fire at all, but there is still preasure in the trigger. can any1 help me

[Flow_Tech]

there is a few things this could be...first off,are you using a preset or adjustable tank?Chances are that if you use a n adjustable,you dont have the psi at a high enough force to activate the valve, it could also be your velocity,check to see if it is turned down,and the only other thing i can think of is bolt stick,try dropping a few dabs of oil into the guns on/off ASA if you have one,and also a drop or 2 into the fitting on the valve..

[jwalker87]

the same thing happened to my friend. He used an HPA tank screwed into an on/off ASA, and he had the on/off screwed in TOO TIGHT. If you screw it in too tight, it blocks the airflow, and doesn't let enough air to the valve. So if you have one, just screw it in enough to open the tank and no farther.

[mcdkid]

...

i have a preset tant, and no on/off, as for the other things i have tried them

[Drizit]

try a shorter bolt spring for your lvl 10, also try a larger carrier it could be that the lvl 10 is set too close to the line and has for some reason stoped releaseing the bolt, also check your sear i had both problems after i installed a lvl 10 in my micro. you can also try to back your tank off from the ASA 1/4 to 1/2 turn some ASA's are screwed up and push the pin to far the same as cranking too hard on an on/off does. but i'm betting it's the lvl 10 setup, another thing could be your trigger rod may be to short.

hope that gets you going

[mcdkid]

...

i'v tried all that, and as far as the lvl10 goes it was installed in december by agdjon (agd tech) and it has worked fine

[mcdkid]

?

any more advice?

[Flossabe]

help

1.Have you mesed with your trigger pull?

4. check your on/off pin length (it probly wont be in the AGD spec. this is ok) what is it. Or have you replaced it when it started happening?

5.is there another mag, mechinical or electric, you can put your valve into?

do all of those things and let me know, micromags can be a pain sometimes but that is all that i have so well get you running again.

[Cool fool!]

do you have enough nitrogen? my trigger pressurises but wont fire if my nitro iz under 800psi. hope that helps.

[mcdkid]

trigger pull

it did start having problems when i tried to get it to rapid fire, but it only did like strings of 3, so i tried to put it back to normal then it started to be a problem

[bunkerhugger]

Pull out the sear and the On/off pin - look for signs of damage to either...

[athomas]

Did it work before with the same setup?

[mcdkid]

yea

every thing used to work fine even with the lvl 10

also the is no damage to the sear or on/off pin

[athomas]

As stated, check that you have lots of air. Sometimes the gauges on the tanks aren't accurate at the lower readings. Make sure the velocity/pressure adjustment is set high enough to operate the level 10. Try going to the smallest bolt spring.

[mcdkid]

air

air isn't a problem worked on it a bit at work (paintball atlanta) filled the tank 2 times still no progress