what if...

[Nimec]

what would hapen if your on/off pin hapend to be bent? could it be the cause of a leak out the back of the gun?

[TheBigRaguPB4L]

nope, a leak out the back has to do with something within the valve body(reg seat, piston o-ring, blow off valve). first thing you really want to check is the velocity. if it's to high, it will leak out the back. next the reg seat and so on.

[Nimec]

no i checked all of those. its not them and the bent pin is the only thing wrong that i can find.

[TheBigRaguPB4L]

did you try trial and error? replacing things with new ones just one at a time and gassing up?

[Nimec]

yeah ive kinda been at it for about 3 weeks. i dont remember having these problems when i was using co2.

[TheBigRaguPB4L]

that could be the blow off valve. you would need a new one if it went. might want to call them up or send it in. well, you'd have to call them up to send it in but you get the point.

[Nimec]

it wasnt the blow off i dont think. i got on agd website and got some blow ups and im prety sure its the on/off.

[TheBigRaguPB4L]

on/off problems usaully cause leak out the front of the gun or in the breach. i'm almost positive it wouldn't be the on/off unless it's leaking out of the side and not the back.

[Nimec]

it only hapens when i turn up my velocity. but if i dont turn it up balls just end up getting five inches out of the barrel. and when i do turn it up it starts squeling and spitting air out.

[TheBigRaguPB4L]

how many threads do you see on the reg nut?

[Nimec]

there are about 17 of them. Why?

[TheBigRaguPB4L]

i mean with the reg screwed into the valve? if you see 17 with it screwed in, you need to tighten that thing. i see 2 on my mag that i run co2 on and that's the furthest out of the 3 i have.

[Nimec]

ohh ok i get it. i see four before it starts leaking.