More E-mag woes

[NJPaint]

ULE E-mag
v 1.37 Board

when the tank is at 2000 psi it shoots a few shots, every few shots the board flashes "AGD 1.37" and then stops working. I pop the yellow pin back in and it works again for a few shots. At the end of the tank, last 50-100 shots the gun performs perfectly and when there is ~800 psi left in the tank it chuffs continuously like a normal e-mag. (ie. When it is low on air the electronics work fine, when it is shooting normal shots it doesn't like it)

Any ideas?

[Tunaman]

Check the ground screw. Make sure its tight.

[RRfireblade]

Bad soleniod.

[NJPaint]

Check the ground screw. Make sure its tight.

Yup, first thing Dayspring told me to try , no change =/.

Bad Solenoid? Do I contact AGD to get fixed?

[RRfireblade]

If it is a bad soleniod,it'll have to go to AGD unless your willing to buy one and try it yourself.

[deadeye9]

It sounds like your E-Mag has an intermittent battery connection. Check the battery terminals, the screws where the terminals touch, and where the wires come onto the circuit board. Also check to be sure the push buttons on the back of the grip frame haven't fallen out and are shorting out the circuit borard.