LVL 10 + Barrel weirdness

Collapse
X
Collapse
 
  • Page of 2
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • athomas
    Of course it works-its AGD
    • Jan 2002
    • 8039
    #16
    It sounds like your body retaining washer is mushroomed a bit. File the hole out in the center of the washer that separates the back and front half of the gun body.

    The barrel could be a bit off center as well. Take the barrel o-rings off. Put a piece of electrical tape around the barrel over each of the barrel o-ring grooves. Put the barrel o-rings back on. Put the barrel on your gun and try it. The barrel will be held more in the center of the body and won't be pushed off to one side by the twist lock assembly.
    Except for the Automag in front, its usually the man behind the equipment that counts.

      Comment

      • Blackice7
        Registered User
        • Apr 2003
        • 68
        #17
        I did both and the barrel seems to be slightly off center still and ways to make the barrel centered again?

          Comment

          • athomas
            Of course it works-its AGD
            • Jan 2002
            • 8039
            #18
            If the barrel is off center, put an additional layer(s) of tape under the barrel o-rings on one side to compensate.
            Except for the Automag in front, its usually the man behind the equipment that counts.

              Comment

              Previous 1 2 template Next
              Working...