Warp won't stop spinning

[headcase]

Ok I got my E-mag today, and was doing the E-mag to Warp and Revy power mod, and the Intelifeed to Warp and Revy(using warp board) mods. Both the warp and revy have power, so that worked out fine.

The problem is when I connect both intellifeed cables, and both power cables the warp and rev won't stop spinning.

I have the second Intelifeed spliced into the wire that connects to the board. Everything is the correct polarity as far as I can tell, and all the connections should be good and insolated( I already ripped it apart and redid all the connections.)

Anyone have any ideas.

[Micromag5371]

ok...i know nothing about warp feeds and intellifeeds, but i have a thought...maybe when you soldered or connected the wires, you lined the wires up wrong and maybe you got 2 power systems running both systems, as well as the gun...the increased voltage could mess up the sensitivity on the warp, which could make it stay "on". i am probably wrong, as i know nothing about these systems. you say you checked it...rip it apart again, and leave it undone. go to your store today and see if they have some shrinkwrap (you want it very very small, so you can make a wireing harness and then shrink it) and rewire all the stuff(put the shrinkwrap on before you even plug the soldering gun in) and fix it all up...then shrinkwrap it, it only adds protection to the wires and helps make sure nothing shorts out.

[headcase]

OK more trouble shooting....

E-mag battery is good and charged.
Output at both 9v connectors is good.
Regulator between power and warp board is working.

So I've come to the conclusion that my power cable, and warp boards are OK.

I checked the connector for the E-mag warp cable on the board. I had the plug in with two wires with stripped ends. Turned power on to the marker, pulled trigger, and had no reading at the mulimeter, I did this with both the warp/revy connected, and with both disconnected with no change.

Does anyone know what the output is supposed to be? I thought it was 5 volts, will someone check there's?

I have a bad feeling I screwed up my board.

Thanx

[Russ]

I get a 1.5 volt output, measured right at the board. The reading is momentary, but that's what I see. My E-Mag battery is fully charged (18.8v)

As far as the other probs, what orientation of jumper, (NOT the dwell jumpers) were you using? I have the middle (positive) and bottom (sensor on) installed. Mine is a Pro-Team Warp, without the internal sensor. I'm using an AGD interlink cable to actuate the Warp.

Hope this helps. Good luck

[headcase]

OK thanx ,

I was expecting a higher output, so I'll change the setting on my multimeter and try again.

I'm pretty sure I've tried all the jumper settings, but I'll go back and try that setting again.

Thanx

[headcase]

OK, still no output at the board, I'm definitely thinking it's gone, I should really learn to stop messing with my new toys

A well, live and learn I guess.

I suppose I'll call and register on Wednesday, and get a RA# at the same time.

Thanx for the assist guys

[headcase]

I forgot something...what does the upper most jack on the E-mag board do? The one NOT next to the others. When I received the E_mag that is where the E-mag/Warp connecter was.

Thanx