Consistency Problems

[Stix]

I'm having consistency problems over the chrono. Besides making sure all the internals are lubed, is there anything else I should look for? It's a ULE custom with an x-valve. It's being powered by an ACI bulldog 800 preset, and the bolt spring is the medium cut one... if any of that matters.

Thanks again.

[Chronobreak]

what kinda of fluctuations we talking about here? how NEW is it it will wokr better once its fully worked in

[Dayspring]

Are you using the RT chrono procedure?

[Stix]

I am using the RT pro procedure... the fluctuations are about +/- 15. The gun has seen about... er... 3 cases? The ACI Bulldog is relatively new though, prolly about 1000 shots.

[mattress]

How's your paint/barrel match?

[AGDlover]

you may need a higher flowing tank/new reguator

[Skoad]

you may need a higher flowing tank/new reguator

I wouldn't jump to that, because its not very likely.

Usually a mags consistency problems are with the reg seat inside the valve. Take a look at it, but be careful. Screwing the valve apart and back together can actually damage it. With AGD's new shipping options you should be able to order one for dirt cheap.

[AGDlover]

but don't Xvalves need 850-1000out put