intelliframe trigger sear adjustment

[adiedanny]

I just purchased an intelliframe. When I rapid fire the gun does not fully recharge every once and a while. Do I have to adjust the trigger sear and if so does anybody know exactly how much adjustment is needed? I previously had a AGD tigger frame installed. Thank you.

[Chronobreak]

welcome to ao
what kind of mag/setup are u running?
the sear SHOULDNT need any adj

[RRfireblade]

The trigger rod should have approx 1/16" of gap between it and the point it contacts the back of the trigger when fully gased up.It's not uncommon the have to correct that adjustment during the change of different branded frames.Check that first and then go from there.

[adiedanny]

intelliframe

Thanks for the clearing that up. I toyed with the sear adjustment and now the valve recharges fine. If the adjustment is not proper could the adjustment cause any damage to my minimag?