Valve Questions..

[flyinasian016]

Ok, I got a friend who is interested in swapping my Emag valve for his Classic Valve. My Emag valve is going on his 68 Classic and his Classic Valve is going onto my Emag, until i get the money for an X-valve. Basically, i was wondering these few things:

What on/off Pin (classic valve or emag) does my friends 68 classic need with an Emag Valve?
What on/off Pin (classic valve or emag) does my Emag need with a Classic Valve?

[athomas]

You need to keep your emag on/off assembly and put it in the AIR valve for you to use the AIR valve on your emag. Your friend needs a retro on/off assembly with a .750" on/off pin to use the emag valve in his gun.

[TraXeR]

If flyinasain was to buy a new on/off pin for his x valve when he gets it... would the emag on/off pin work for the classic valve instead of an rt pin?

[athomas]

That's what I said.

Use the emag .712 on/off pin(and of course the assembly that goes with it) in the AIR valve when it is used in the emag frame.

I'm not sure if the AIR valve on/off assembly will work in the emag valve though. If it is a newer valve maybe, but the older valves with the the single on/off top o-ring may not accept the AIR valve on/off pin. Try it.

When the Xvalve is purchased, keep the on/off assembly in it and put the original .712 emag on/off pin in it for use in the emag. Put the original emag on/off assembly back into the emag valve along with the new .750 on/off pin.