Hyperframe problem

[TwoFatGuysPaintball]

put hyperframe on my mag and it works but if you tighten the back trigger screw all the way down it will not shoot. Any help or advise will be awsome

[GA Devil]

you may be making it so tight that the trigger dont move far enough to de-activate the switch and leaving the switch activated. loosen the screw some and slowly squeeze to listen for the click of the switch . Thats the shortest it can be. Let me know if this helps.

[ZapTheMad]

My bolt sticks if I tighten the quick strip screw. I have to leave it almost loose.

[GA Devil]

what body? if ule i have noticed that if you dont have it set right or there is a blemish in the rail it offsets the body a bit and cause the bolt to smack the inside top of the body. Pull your body off and look thru the slot the sear sits and see if its worn there. If so thats is a good chance of what is happening.

[ZapTheMad]

yeah, it does hit the body. I think i'll shim it up behind the screw with some tape and see what happens.

[GA Devil]

actually u need to bring the front up not the back...your pivoting forward causeing it to hit the top

[TwoFatGuysPaintball]

yeah thats the problem with mine also that the sear is not lining up. will try and reset the sear and raise up the front of the body to see if that works thanks again