Intelliframe Problem

[Almeister]

I just put a new Intelliframe on my 68 Automag now here's the problem...I can't fire more than two shots rapidly while dry firing if I do the bolt just vents everytime i keep pulling the trigger. I have to wait like one second before I can fire again. I also noticed after releasing the trigger the bolt would take a second to click back forward. Now when I put the stock frame back on I could fire as fast as I could pull the trigger with no problem. I can't figure out what's wrong. Can someone HELP?

Marker Setup

68 Automag w/ powerfeed
Intelliframe w/ blade trigger
Retro Valve
LvL 10 w/ 1.5 carrier, 2 shims, & shortest spring
Crossfire 68/4500

[pointm@n]

Do you have the rail bushing? Are you using an allen wrench to tighten the field strip bolt?

[Almeister]

Do you have the rail bushing? Are you using an allen wrench to tighten the field strip bolt?

Yes. No.

[adiedanny]

intelliframe

I was having the same problem with my intelliframe. What I did was adjust the trigger sear to 1/16" . I turned the sear clockwise ( shorten the length) until I only had 1/16" dastance between my frame and trigger. Check out my threads, RRFireblade confirmed the adjustment.

[Almeister]

I tried doing that and it still doesn't work right. My marker only works right when the stock frame is on. Any other suggestions???

[adiedanny]

intelliframe

Try adjusting the velocity, make sure both bolts are properly tightened, try cleaning your valve and make sure you have plenty of air. Other than that I have no other idea. Good luck

[Almeister]

So far no luck....looks like i might have to send it in to AGD and see if they can figure out whats wrong. Thanks for the help anyways.