Newbish cocker question

[SCpoloRicker]

Hey all

I posted this at AIR, but I figure I'll ask here as well

Anywhoo... I am a relative cocker newb, and I have a basic question.

I pulled out one of the hoses that connects the 3 way to the... uhhh thingie... I believe that its not the LPR, which is the larger tube...

I know where it's supposed to go, but when I hand connected the tube and gassed up, there was a definate leak. Is there a process for making that seal good again? Am this the start of madness? Or normal issue?

Only owned it for about two months, gotten 7-9 days in playing with it. Thus far, no problems, just clean it best you can and lube after every day.

Thanks,

Ricker

[redlaser666]

If you are reusing the same hoses you may want to trim the ends a bit, since they normaly expand when you pull them off. That may be causing your leak.

Trim the end of the hoses and make sure that when you reconnect them they go in tight.