Lol.. not sure what kind of problem this is, but it's not good.

[TraXeR]

I oiled up my mag the other day, after recently getting a RT Valve and a Level 10 with ULT. All fits together fine, so that's good.

Now.. I air up my gun, I get a leak down the barrel, uh oh. So I pull the trigger... *bang* Sssssss. After about 2 seconds, the leak is gone. So I let go of the trigger. sssSSSSSSSS. The leak is back.

Rinse and repeat.

Any ideas? The guy who i had trading it from before said just putting oil on the on off would fix it, but being heavily oiled... it's still happening, so I assume it's a problem with my level 10.

[Chicago Pb 7]

I had a similar problem a little while ago, have you changed your lvl 10 setup at all? You might want to try the shortest spring, 2 shims and the 2.0 carrier, and clean and relube everything.

[TraXeR]

I had a similar problem a little while ago, have you changed your lvl 10 setup at all? You might want to try the shortest spring, 2 shims and the 2.0 carrier, and clean and relube everything.

No, I didn't change it, and he told me that it was working fine before on his emag too.

[�?�� �m���]

where does it sound like its leaking?
down inside the barrel? (that would be carrier oring or carrier size)
you would hear sSSs from the area its leaking from and if your holding down the trigger its something with the valve or reg
not the on/off (if you were holding down the trigger the on/off would still leak if this was the problem)


(i think i had the same problem as you)

[danheneise]

No, I didn't change it, and he told me that it was working fine before on his emag too.

there's your problem right there, not all mags are the same, one setup may work great for one person but won't necessarily work for another. I'd say, pull out your L10 assembly and check for the proper carrier size, it sounds like that's a bit too large. also see how many shims are in there, too many can cause leakage, to little amount of shims and you might get bolt stick.

[TraXeR]

Thanks for the help guys, I'll do it tomorrow, cause I'm out of air right now, so I'll see how it works.

[binker]

i have a similiar problem with my automag 68 classic, it does not have a level 10 bolt, but the air is goming out of the regulator and the trigger wont pressurize, if that makes any sense, what could i do to stop that

[flyinasian016]

i have a similiar problem with my automag 68 classic, it does not have a level 10 bolt, but the air is goming out of the regulator and the trigger wont pressurize, if that makes any sense, what could i do to stop that

are you using a ULT?