Warp Problems...

[Magsrule3]

Well my PTP Warp Feed is making me a little mad. It took me a lot of paint and air to figure out the prob. It wasn't spinning with each shot so I messed with the sensitivity and it didnt work. It turned out that the wire that runs from the vibe. plate to the board is ruined. So where do I get a new vibe. sytem(or actually a whole new mounting bracket since the screws are stuck in the adjuster part) ? Do I call AGD or PTP?

------------------
-68 Classic Automag
-SP Proggresive barrel
-Lapco drop forward
-PMI gas through
-12 volt revolution
-Crossfire 68CI 3K Stubby
-Microline fittings
-WARP FEED
-16" CP barrel
-ANS sight rail

[BlackVCG]

Call PTP about the vib sensor in the mounting bracket. That's a PTP product, AGD just makes the Warp and everything else is made by PTP.

[Magsrule3]

thanks, i'll try emailing and calling them.

------------------
-68 Classic Automag
-SP Proggresive barrel
-Lapco drop forward
-PMI gas through
-12 volt revolution
-Crossfire 68CI 3K Stubby
-Microline fittings
-WARP FEED
-16" CP barrel
-ANS sight rail